Fenix HP30R V2.0 is a professional headlamp offering 3000 lumens with spotlight and floodlight capabilities. It features a detachable battery case that doubles as a power bank, providing extended runtime and convenience for search and rescue operations. Designed with a durable and waterproof construction, the HP30R V2.0 is suitable for high-performance lighting needs in challenging environments.

STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.

The newest Mandeye System generation under development. It is an enhanced and intuitive system based on the Pro system, that meant to be for end user that needs no training on scanning, mapping and less familiar to particular electronics operations, despite its adaptability for drone mapping is one of its strength. M-Direct is the lightest, with the head weighted only 337 gr. and on batteries the total weight is 653 gr. Its total dimensions are 6,5cm x 10,5 cm x 11,5 cm. Available ASAP as a limited editions and most affordable solution.

This plastic boat with polyethylene material is very impact resistant. This lifeboat is different from an inflatable boat. This plastic boat does not need to be blown or inflated and cannot leak even when it crashes into rocks, into a jetty, or into another boat. This plastic boat can be used as a means of transportation on lakes, in rivers, in wamps or in calm seas. This lifeboat is equipped with two plastic oars, but this Keman Boat can also be fitted with an outboard motor. The Keman Boat plastic boat is very environmental friendly because it is made from raw materials and an environmentally friendly production process.