To augment land, sea, and air defense, Mitsubishi Electric supplies a comprehensive range of space systems intended for defense applications. This includes Communications & Observation Satellites, Ground Infrastructure, Space Situational Awareness Systems, and Satellite Data Solutions.

The 120mm mortar shot is designed to defeat open-air or field-based personnel and equipment, suppressing fire points and destroying wire barriers in different climates. For firing these shots used 120-mm mortars: 2C12, PM-38, 2B11, PM43.

We have a global network of leading defense partners and are currently developing a new ammunition factory focused on small-caliber rounds, with an annual capacity of 300 million rounds.

STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.